Antipollution indicator, loss of power or regeneration impossible? Understand the causes of a plugged FAP and possible solutions before replacement.

Engine light on, loss of power, message "COLLECTION OF COLLECTION OF THE PARTICLESE FILTER" or more and more frequent regenerations? One filter with clogged or highly dirty particles may cause different malfunctions on a diesel engine.
The FAP (particulate filter), also called DPF – Diesel Particulate Filter, is part of the vehicle's clearance system. Its role is to retain a large portion of the particles present in the exhaust, before phasing out gradually with the regeneration process.
When this regeneration is no longer correctly, the particles accumulate and the filter can gradually clog. Let's see how to recognize the symptoms, understand the causes and know when a cleaning or replacement of the FAP may be necessary.
You already search for a replacement room? Consult our selection of new FAP Particle Filters for many brands and engines.
What is the FAP particle filter ?
The particle filter is installed on the exhaust line of many diesel vehicles. It recovers the particles from the combustion to reduce their release into the atmosphere.
As kilometers, these particles accumulate in the filter. The vehicle periodically triggers a regeneration of the FAP : the exhaust gas temperature increases enough to burn some of the stored particles.
This process is normally automatic. But certain conditions of use or certain motor defects can prevent regenerations from proceeding properly.

What are the symptoms of a plugged FAP ?
Symptoms may vary depending on the vehicle, motorization and fouling level. Several signs can nevertheless be thought about a collimated particle filter.
1. FAP LED or LED LED ON
One of the most common signs is the appearance of a light or message on the dashboard concerning the antipollution system.
Depending on the vehicle, the driver can see a message of the type:
- risk of clogging of the particulate filter ;
- particulate filter to clean ;
- anti-pollution fault ;
- engine anomaly ;
- make the engine control.
CAUTION: A motor light does not automatically mean that the FAP must be replaced. A diagnosis is necessary to precisely determine the origin of the defect.
2. Loss of power
When the circulation of exhaust gases becomes difficult, the engine can lose power. The calculator can also voluntarily limit performance to protect the engine and the antipollution system.
The vehicle can then go into degraded mode, with reduced acceleration and sometimes a limited engine speed.
3. Very frequent FAP regenerations
A vehicle that tries to regenerate its filter much more often than before may indicate that the particle level increases rapidly or the previous regenerations could not be completed correctly.
4. Fuel consumption rising
The regeneration phases may require more fuel to increase the temperature of the exhaust. If these cycles become very common, an increase in consumption can be observed.
5. Fan that continues to work
On some vehicles, the fan can continue to operate after the engine stop when a regeneration was in progress or the exhaust system temperatures were high.
This isolated phenomenon is not necessarily synonymous with failure, but it becomes very common and accompanies other symptoms, a check can be useful.
Why is a particle filter getting on ?
A FAP can gradually be charged in particulate during its normal operation. The problems appear mainly when the conditions necessary for its regeneration are no longer met.
Repeated short trips
Small urban trips, with many starts and stops, do not always allow the engine and exhaust to reach long enough the temperatures necessary for a complete regeneration.
By force of interrupted regenerations, the particles can accumulate in the filter.
Engine fault or anti-pollution system
A fap that is getting on quickly can sometimes be the consequence of another problem. It is therefore important to look for the cause before replacing the room.
Among the elements to be controlled may include:
- the EGR valve ;
- the differential pressure sensor ;
- exhaust gas temperature probes ;
- the injection system ;
- the flowmeter ;
- the turbo and its admission circuit ;
- some motor sensors ;
- the general combustion of the engine.
A egr valve fouled or defective in particular, disrupting the operation of the depollution system and contribute to excessive accumulation of soot.
Defective differential pressure sensor
The calculator uses the information provided by the differential pressure sensor to evaluate the restriction caused by the filter.
An incorrect measurement may result in regeneration management defects or to believe a clogging that must be confirmed by a diagnosis.
FAP arrived at the end of life or damaged
Regeneration eliminates a portion of the particles, but it does not undefine the filter in its original state.
With mileage, some non-combustible residues can stay in the filter. this can also be damaged, cracked or damaged by excessive temperature.
Can we clean a clogged fap ?
It depends on the actual state of the filter and the origin of the problem.
When essentially an accumulation of particles and the filter is not physically damaged, different solutions can be considered after diagnosis:
- normal regeneration during adapted driving conditions ;
- forced regeneration carried out with diagnostic equipment when the manufacturer authorizes it ;
- professional cleaning of the disassembled filter.
On the other hand, a cracked filter, melted, deteriorated or strongly charged in residues may require replacement.

When should the particulate filter replace ?
There is no single mileage applicable to all vehicles. The service life depends on the engine, the type of FAP, the use of the vehicle, its maintenance and the proper functioning of the other components.
The replacement can especially be considered when:
- the filter is physically damaged ;
- cleaning is no longer possible or efficient ;
- counterprise pressure remains excessive after control ;
- the filter contains a significant amount of residues that are not eliminated by regeneration ;
- a diagnosis confirms that the FAP itself is defective.
In this case, find on AutoTruck42 our range of new FAP / DPF Particle Filters for Car.
How to choose the right FAP for his vehicle ?
The selection of a particulate filter should not be performed only from the brand and model of the vehicle.
Several montages may exist on the same car:
- the motorization ;
- power ;
- the year of production ;
- the anti-pollution standard ;
- the type of exhaust line ;
- the manufacturer reference used at the time of manufacture.
The most reliable method is to control the oEM / OE REFERENCE present on the old room and compare it to the references indicated on the product sheet.
The general shape of the filter, flanges, fastening brackets, probes and connections are also compared.
In case of doubt before order, send AutoTruck42 your registration, the reference of the original room and photos of the FAP to facilitate verification.
Can we continue to ride with a stuffy fap ?
Continue to use a long time a vehicle with a large particle filter fault is not recommended.
Excessive back pressure in the exhaust can disrupt engine operation. The vehicle can also switch to degraded mode and eventually fail to perform its regenerations normally.
When a FAP indicator stays on, a strong loss of power appears or multiple engine faults are present, a quick diagnosis makes it possible to avoid replacing unnecessarily parts and to determine the actual cause of the problem.
Why can a new FAP be refocusing quickly ?
This is a particularly important point: replace a particulate filter without correcting the cause of its old clogging can lead to the same problem on the new FAP.
Before or during replacement, so it is advisable to check the operation of the engine and the depollution system.
Excessive production of soot, a defective EGR valve, an injection problem, miscarriage from a sensor or impossible regenerations may result in a new clogging.
FAP, DPF and particulate filter: Is it the same thing ?
In the current automotive language, FAP means "particle filter" while DPF corresponds to the English name "Diesel Particulate Filter."
These expressions are therefore commonly used to designate the same family of depollution parts intended to retain the particles present in the exhaust.
FAQ: Filter with plugged particles
What are the first symptoms of a stuffy FAP ?
The most common signs are a FAP or motor indicator, an anti-pollution message, loss of power, frequent regenerations or increased consumption. These symptoms must be confirmed by a diagnosis.
Does a plugged FAP cause a loss of power ?
Yes, a highly clogged filter can increase the exhaust gas exhaust resistance. The calculator can also place the vehicle in degraded mode.
Can we open an FAP without replacing it ?
In some cases, yes. Regeneration or professional cleaning may be possible if the filter is not deteriorated. The solution depends on the level of clogging and the cause of the defect.
Why my fap is often open ?
Repeated short journeys can promote fouling, but an EGR, injection, pressure sensor or other motor element may also prevent the normal operation of the system.
How to find the right particle filter ?
It is recommended to search for the OEM reference on the original FAP and then check the motorization, the year of the vehicle, the shape of the room and the different connections.
Find your Particulate Filter on Autotruck42
Autotruck42 offers a selection of new FAP and DPF particulate filters for many automotive brands: Peugeot, Citroën, BMW, Renault, Mercedes-Benz, Ford, Volkswagen, Audi, Fiat and many others according to the references available.
Search by manufacturer reference or reference OEM often allows the part corresponding to the original mounting more quickly.
Retrouvez notre catalogue de pièces auto et poids lourds.